Kawasaki Ninja Service Manual: Charging System

Kawasaki Ninja Service Manual / Electrical System / Charging System

Refreshing Charge
Remove the battery (see Battery Removal). Do refresh charge by following method according to the battery terminal voltage. WARNINGThis battery is sealed type. Charge with current ...

Alternator Cover Removal
Remove: Upper Fairing Assembly (see Upper Fairing Assembly Removal in the Frame chapter) Air Cleaner Housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter) Bolt [A] ...

Other materials:

Tie-Rod Removal
Squeeze the brake lever slowly and hold it with a band [A]. Remove the front footpeg bracket bolts [A]. Raise the rear wheel off the ground with the jack (see Rear Shock Absorber Removal). Special Tools - Jack: 57001-1238 Jack Attachment: 57001-1608 Remove: Upper ...

DFI System Wiring Diagram (KIBS Equipped Models)
1. Air Intake Solenoid Valve (Other than US, CA and CAL Models) 2. Engine Stop Switch 3. Starter Button 4. Air Switching Valve 5. Stick Coil #1, #2, #3, #4 6. Spark Plugs 7. Intake Air Temperature Sensor 8. Crankshaft Sensor 9. Secondary Fuel Injector #1 10. Secondary Fuel Injector #2 ...

Fuel Pump Relay Inspection
Refer to the Relay Circuit Inspection in the Electrical System chapter. If the fuel pump relay is normal, check the wiring to the fuel pump relay (see Fuel Pump Relay Circuit). Special Tool - Hand Tester: 57001-1394 If the wiring is good, check the ECU for its ground and power supply (se ...