Kawasaki Ninja Service Manual: Throttle Body Assy

Kawasaki Ninja Service Manual / Fuel System (DFI) / Throttle Body Assy

Idle Speed Inspection

Refer to the Idle Speed Inspection in the Periodic Maintenance chapter.

Synchronization Inspection/Adjustment

Refer to the Engine Vacuum Synchronization Inspection in the Periodic Maintenance chapter.

Throttle Grip and Cables
Free Play Inspection Refer to the Throttle Control System Inspection in the Periodic Maintenance chapter. Free Play Adjustment Refer to the Throttle Control System Inspection in the Periodic Mai ...

Throttle Body Assy Removal
WARNINGGasoline is extremely flammable and can be explosive under certain conditions, creating the potential for serious burns. Make sure the area is well-ventilated and free from ...

Other materials:

Switch Inspection
Using a hand tester, check to see that only the connections shown in the table have continuity. Special Tool - Hand Tester: 57001-1394 For the switch housings and the ignition switch, refer to the tables in the Wiring Diagram. If the switch has an open or short, repair it or replace it w ...

Release Shaft Installation
Apply grease to the oil seal lips on the upper ridge of the clutch cover. Apply engine oil to the needle bearings in the hole of the clutch cover. Applymolybdenum disulfide grease to the pusher-holding portion [A] on the release shaft. Install the washer [B] and spring [C]. ...

Exhaust Pipe Installation
Replace the exhaust pipe gaskets [A] and premuffler chamber gasket [B] with new ones. Install the premuffler chamber gasket to the premuffler chamber [C] until it is bottomed so that the chamfer side faces exhaust pipe [D]. Install the exhaust pipe clamp [E] as shown in the figure. I ...