Kawasaki Ninja Service Manual: KIBS Solenoid Valve Relay Inspection (Service Code b 19)

Kawasaki Ninja Service Manual / Self-Diagnosis System / KIBS Service Codes (KIBS Equipped Models) / KIBS Solenoid Valve Relay Inspection (Service Code b 19)

The KIBS solenoid valve relay is built in the KIBS Hydraulic Unit. Therefore the relay cannot be checked directly.

If this service code appears even if all checks are ended, replace the KIBS hydraulic unit.

If the service code does not appear, the KIBS system normal (temporary failure).

Solenoid Valve Inspection (Service Code b 13, b 14, b 17, b 18)
The solenoid valve is built in the KIBS Hydraulic Unit [A]. Therefore the solenoid valve cannot be checked directly. Perform the Pre-Diagnosis Inspection 1 and 2 (see Inquiries to Rider in th ...

Front, Rear Wheel Rotation Difference Abnormal Inspection (Service Code b 25)
Check the following and correct the faulty part. Incorrect Tire Pressure Tires not recommended for the motorcycle were installed (incorrect tire size). Deformation of Wheel or Tire Mi ...

Other materials:

Shifting Gears
Close the throttle while pulling in the clutch lever. Shift into the next higher or lower gear. Open the throttle part way, while releasing the clutch lever. For smooth riding, each gear position should cover the proper rate of speed shown in the table. WARNINGDownshifti ...

Wheel Alignment Inspection
Check that the notch [A] on the alignment indicator [B] aligns with the same swingarm mark or position [C] that the other side alignment indicator notch aligns with. If they do not, adjust the chain slack and align the wheel alignment (see Drive Chain Slack Adjustment). NOTE Wheel align ...

Swingarm Bearing Installation
Replace the needle bearings, ball bearing, grease seals and circlip with new ones. Install the needle bearings, ball bearing, grease seals and circlip as shown in the figure. Insert the needle bearing driver [A] into the needle bearing [B] and press the needle bearing into the housing u ...