Kawasaki Ninja Service Manual: Steering

Kawasaki Ninja Service Manual / Periodic Maintenance / Periodic Maintenance Procedures / Steering

Tie-Rod Operation Inspection
Pump the rear seat down and up 4 or 5 times, and inspect the smooth stroke. If the tie-rod [A] do not smoothly stroke or noise is found, inspect the fasteners and tie-rod bearings (see Tie-R ...

Steering Play Inspection
Remove the lower fairings (see Lower Fairing Removal in the Frame chapter). Raise the front wheel off the ground with the jack. Special Tools - Jack: 57001-1238 Jack Attachment: 57001-1608 ...

Other materials:

Outline
When a problem occurs with DFI system, the warning indicator light (LED) [A] and FI warning symbol [B] goes on to alert the rider. In addition, the condition of the problem is stored in the memory of the ECU. For models equipped with an immobilizer system, the warning indicator light (LED) and ...

Gear Position Switch Inspection
NOTE Be sure the transmission and external shift mechanism are good condition. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the connector [A]. Set the hand tester [A] to the × 1 kΩ or × 100 Ω range and connect i ...

Handlebar Installation
Apply a non-permanent locking agent to the threads of the handlebar positioning bolts and tighten them. Torque - Handlebar Positioning Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb) Install the steering stem head with handlebars. Install the washer [A] and steering stem head nut [B]. Tighten: ...