Kawasaki Ninja Service Manual: Air Intake Duct Removal

Kawasaki Ninja Service Manual / Fuel System (DFI) / Air Line / Air Intake Duct Removal

Air Intake Duct Removal


Air Line
...

Air Intake Duct Installation
Check that the pad [A] is in place on the air intake duct. Apply a non-permanent locking agent to the threads of the air intake duct mounting bolts, and tighten them. Run the lead correctly ( ...

Other materials:

Transmission Shaft Disassembly
Remove the transmission shafts (see Transmission Shaft Removal). Remove the circlips, and then disassemble the transmission shafts. Special Tool - Outside Circlip Pliers: 57001-144 The 5th gear [A] on the output shaft has three steel balls assembled into it for the positive neutral fin ...

Water Temperature Sensor Removal/Installation
NOTICE Never drop the water temperature sensor especially on a hard surface. Such a shock to the sensor can damage it. Remove the throttle body assy (see Throttle Body Assy Removal in the Fuel System (DFI) chapter). Drain the coolant (see Coolant Change in the Periodic Maintenance c ...

Ball Bearing and Needle Bearing
Do not remove pressed ball or needle unless removal is absolutely necessary. Replace with new ones whenever removed. Press bearings with the manufacturer and size marks facing out. Press the bearing into place by putting pressure on the correct bearing race as shown. Pressing the incorrect ra ...