Kawasaki Ninja Service Manual: Radiator

Kawasaki Ninja Service Manual / Cooling System / Radiator

Mechanical Seal Inspection
Remove the impeller (see Oil Pump Removal in the Engine Lubrication System chapter). Visually inspect the mechanical seal. If any one of the parts is damaged, replace the mechanical seal as ...

Radiator and Radiator Fan Removal
Remove: Upper Fairing Assembly (see Upper Fairing Assembly Removal in the Frame chapter) Coolant (Drain, see Coolant Change in the Periodic Maintenance chapter) Air Cleaner Housing (see A ...

Other materials:

Turn Signal Relay Inspection
Remove the battery (see Battery Removal). Take the turn signal relay [A] off the rear fender. Disconnect the connector [B]. Connect one 12 V battery and turn signal lights as indicated in the figure, and count how many times the lights blink for one minute. Turn Signal Relay ...

Operating Procedures
Clean the seat area carefully. Coat the seat with machinist’s dye. Fit a 45° cutter into the holder and slide it into the valve guide. Press down lightly on the handle and turn it right or left. Grind the seating surface only until it is smooth. NOTICE Do not grind the seat too ...

Parts Location
1. Timing Rotor 2. Crankshaft Sensor 3. Horn 4. Oil Pressure Switch 5. Rear Brake Light Switch 6. Oxygen Sensor (Equipped Models) 7. Alternator 8. Stator Coil 9. Gear Position Switch 10. Sidestand Switch 11. Immobilizer Amplifier (Equipped Models) 12. Radiator Fan Motor 1 ...