Kawasaki Ninja Service Manual: Electrical System

Kawasaki Ninja Service Manual / Periodic Maintenance / Periodic Maintenance Procedures / Electrical System

Steering Damper Oil Leak Inspection
Visually inspect the steering damper [A] for oil leakage. If the oil leakage is found on it, replace the steering damper with a new one (see Steering Damper Removal/ Installation in the Steeri ...

Lights and Switches Operation Inspection
First Step Set the gear position in the neutral position. Turn the ignition switch to ON. The following lights should go on according to below table. If the following light does not go ...

Other materials:

Oil Pan Installation
If the oil filter holder bolt [A] was removed, tighten it. Apply a non-permanent locking agent to the threads of the oil filter holder bolt. Torque - Oil Filter Holder Bolt: 35 N·m (3.6 kgf·m, 26 ft·lb) Replace the O-rings [B] with new ones, and apply grease to them. Install the O-ri ...

Alternator Inspection
There are three types of alternator failures: short, open (wire burned out), or loss in rotor magnetism. A short or open in one of the coil wires will result in either a low output, or no output at all. A loss in rotor magnetism, which may be caused by dropping or hitting the alternator, by leav ...

Fuel Tank Removal
WARNINGGasoline is extremely flammable and can be explosive under certain conditions, creating the potential for serious burns. Make sure the area is well-ventilated and free from any source of flame or sparks; this includes any appliance with a pilot light. Do not smoke. T ...