Kawasaki Ninja Service Manual: Drive Chain

Kawasaki Ninja Service Manual / Final Drive / Drive Chain

Exploded View
HG: Apply high-temperature grease. HO: Apply heavy oil. L: Apply a non-permanent locking agent. MO: Apply molybdenum disulfide oil solution. (mixture of the engine oil and molybden ...

Drive Chain Slack Inspection
Refer to the Drive Chain Slack Inspection in the Periodic Maintenance chapter. Drive Chain Slack Adjustment Refer to the Drive Chain Slack Adjustment in the Periodic Maintenance chapter. Wheel A ...

Other materials:

Check 3-3: High Beam Indicator Light (LED) Inspection
Connect the leads in the same circuit as Check 3-2. Connect the terminal [7] to the battery (+) terminal. Check that the high beam indicator light (LED) [A] goes on. If the indicator light does not go on, replace the meter unit. ...

Vehicle-down Sensor Installation
Be sure to install the rubber dampers [A] and collars [B] on the bracket. The UP mark [A] of the sensor should face upward. WARNINGIncorrect installation of the vehicle-down sensor could cause sudden loss of engine power. The rider could lose balance during certain ...

Valve-to-Guide Clearance Measurement (Wobble Method)
If a small bore gauge is not available, inspect the valve guide wear by measuring the valve to valve guide clearance with the wobble method as indicated below. Insert a new valve [A] into the guide [B] and set a dial gauge against the stem perpendicular to it as close as possible to the cy ...