Kawasaki Ninja Service Manual: Air Intake Solenoid Valve

Kawasaki Ninja Service Manual / Electrical System / Air Intake Solenoid Valve

Air Switching Valve
Air Switching Valve Operation Test Refer to the Air Suction System Damage Inspection in the Periodic Maintenance chapter. Air Switching Valve Unit Test Remove the air switching valve (see Air ...

Air Intake Solenoid Valve Operation Test
Start the engine and run it at idle speed. Check the air intake valve [A] as follows. When the engine is running, the air intake valve is lifting up. If the valve does not operate properly, ...

Other materials:

Safe riding technique
The points given below are applicable for everyday motorcycle use and should be carefully observed for safe and effective vehicle operation. For safety, eye protection and a helmet are strongly recommended. You should be aware of and verify the applicable safety regulations in force prior ...

Tie-Rod and Rocker Arm Bearing Removal
Remove: Tie-Rod (see Tie-Rod Removal) Rocker Arms (see Rocker Arm Removal) Swingarm (see Swingarm Removal) Sleeves [A] Oil Seals [B] Remove the needle bearings [C], using the bearing remover head and bearing remover shaft. Special Tools - Bearing Remover Head, 15 × 17: ...

Crankshaft Side Clearance Inspection
Insert a thickness gauge [A] between the thrust washer [B] on the crankcase and the crank web [C] at the #3 main journal to determine clearance. If the clearance exceeds the service limit, replace the thrust washers as a set and check the width of the crankshaft #3 main journal. Cra ...