Kawasaki Ninja Service Manual: Thermostat

Radiator Filler Neck Inspection

Remove: Radiator Cap (see Coolant Change in the Periodic Maintenance chapter) Check the radiator filler neck for signs of damage. Check the condition of the top and bottom sealing seats [ ...

Thermostat Removal

Remove: Fuel Tank (see Fuel Tank Removal in the Fuel System (DFI) chapter) Air Cleaner Housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter) Throttle Body Assy (see T ...

Other materials:

Compression Damping Force Adjustment
To adjust the compression damping force, turn the compression damping adjuster [A]. The standard adjuster setting is the 4 1/2 turns out from the fully clockwise position. WARNINGIf both adjusters are not adjusted equally, handling may be impaired and a hazardous condition ma ...

Connecting Rod Big End Bearing Insert/Crankpin Wear Inspection
Remove the connecting rod big end (see Connecting Rod Removal). Cut strips of plastigage to crankpin width. Place a strip on the crankpin parallel to the crankshaft installed in the correct position. Tighten the connecting rod big end nuts to the specified torque (see Connecting Rod I ...

Starter Motor Disassembly
Remove the starter motor (see Starter Motor Removal). Take off the starter motor through bolts [A] and remove the both end covers [B]. Pull out the armature [A] out of the yoke [B]. NOTE Do not remove the circlip [C] from the shaft. Remove the starter motor terminal lock ...