Kawasaki Ninja Service Manual: Guard

Kawasaki Ninja Service Manual / Frame / Guard

Windshield
Windshield Removal Remove: Bolts [A] and Washers Windshield [B] Windshield Installation Be sure to install the wellnuts [A] and the washers. Tighten: Torque - Windshield Mounti ...

Mud Guard Removal
Remove: Mud Guard Mounting Bolts [A] Clamp (Right Side) Brake Hose Banjo Bolt of Rear Caliper Side (see Rear Caliper Removal in the Brakes chapter) Mud Guard [B] ...

Other materials:

Caliper Fluid Seal Damage
The fluid seal (piston seal) [A] is placed around the piston to maintain clearance between the pad and the disc. If the seal is in a poor condition, it could lead the pad to wear excessively or the brake to drag, which may cause the temperature of the discs or the brake fluid to increase. Re ...

Oil and/or Oil Filter Change
To change the engine oil and replace oil filter, the engine oil drain bolt and oil filter must be removed. The oil change and oil filter replacement should be done by an authorized Kawasaki dealer. A. Engine Oil Drain Bolt A. Oil Filter WARNINGEngine oil is a toxic s ...

Crankshaft Sensor Peak Voltage Inspection
Refer to the Crankshaft Sensor Peak Voltage Inspection in the Electrical System chapter. If the reading is within the standard, remove the ECU and check the wiring for continuity between harness connectors. Special Tool - Hand Tester: 57001-1394 Disconnect the ECU and sensor connector ...