Kawasaki Ninja Service Manual: Coolant

Coolant Flow Chart

1. Radiator 2. Radiator Fan 3. Water Pump 4. Oil Cooler 5. Oil Cooler Intake Hose 6. Oil Cooler Outlet Hose 7. Cylinder Jacket 8. Cylinder Head Jacket 9. Thermostat Housing 10. Air Bleede ...

Coolant Deterioration Inspection

Remove the right lower fairing (see Lower Fairing Removal in the Frame chapter). Visually inspect the coolant in the reserve tank [A]. If whitish cotton-like wafts are observed, aluminum par ...

Other materials:

Drive Chain
The drive chain slack and lubrication must be checked each day before riding the motorcycle and must be maintained in accordance with the Periodic Maintenance Chart for safety and to prevent excessive wear. If the chain becomes badly worn or maladjusted - either too loose or too tight - the c ...

Cylinder Head Cover Removal
Remove: Air Suction Valves (see Air Suction Valve Removal) Throttle Body Assy (see Throttle Body Assy Removal in the Fuel System (DFI) chapter) Stick Coils (see Stick Coil Removal in the Electrical System chapter) Remove the clamps [A]. Turn up the front side of the heat insulation ...

Throttle Body Assy Holder Installation
Be sure to install the new O-rings [A]. Using a high flash-point solvent, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clean cloth. Apply silicone sealant to any two positions of the new O -ring. Sealant - Liquid Gasket, TB1211F: 92104-0 ...