Kawasaki Ninja Service Manual: Camshaft Chain Installation

Camshaft Chain Removal

Remove: Camshafts (see Camshaft Removal) Timing Rotor (see Timing Rotor Removal in the Electrical System chapter) Front and Rear Camshaft Chain Guides (see Cylinder Head Removal) Remove ...

Cylinder Head

...

Other materials:

Cam Wear Inspection
Remove the camshafts (see Camshaft Removal). Measure the height [A] of each cam with a micrometer. If the cams are worn down past the service limit, replace the camshaft. Cam Height Standard: Exhaust 35.043 35.157 mm (1.3796 1.3841 in.) Intake 38.243 38.357 mm (1.5056 1.5101 in. ...

Coupling Bearing Inspection
Since the coupling bearing is made to extremely close tolerances, the clearance can not normally be measured. NOTE It is not necessary to remove the coupling bearing for inspection. If the bearing is removed, it will need to be replaced with a new one. Turn the bearing in the coupling b ...

Coupling Bearing Installation
Replace the bearing with a new one. Press in the bearing [A] until it is bottomed. Special Tool - Bearing Driver Set [B]: 57001-1129 Pack the bearing with high-temperature grease. Replace the circlip with a new one. Special Tool - Inside Circlip Pliers: 57001-143 Replace the grease se ...