Kawasaki Ninja Service Manual: Water Temperature Sensor

Kawasaki Ninja Service Manual / Cooling System / Water Temperature Sensor

Water Temperature Sensor Removal/Installation

Refer to the Water Temperature Sensor Removal/Installation in the Self-Diagnosis System chapter.

Water Temperature Sensor Inspection

Refer to the Water Temperature Sensor Inspection in the Electrical System chapter.

Hoses and Pipes
Hose Installation Install the hoses and pipes, being careful to follow bending direction. Avoid sharp bending, kinking, flattening or twisting. Run the hoses (see Cable, Wire, and Hose Routi ...

Engine Top End
...

Other materials:

Valve Seat Repair
Repair the valve seat with the valve seat cutters [A]. Special Tools - Valve Seat Cutter Holder Bar [B]: 57001 -1128 Valve Seat Cutter Holder, 4.5 [C]: 57001 -1330 [For Exhaust Valve Seat] Valve Seat Cutter, 45° - 27.5: 57001-1114 Valve Seat Cutter, 32° - 28: 57001-1119 Valve Seat ...

Intake Air Pressure Sensor #1 Removal
NOTICE Never drop the intake air pressure sensor #1 especially on a hard surface. Such a shock to the sensor can damage it. Remove: Air Cleaner Housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter) Intake Air Pressure Sensor #1 Connector [A] Remove the intake air ...

Connecting Rod Big End Bearing Insert/Crankpin Wear Inspection
Remove the connecting rod big end (see Connecting Rod Removal). Cut strips of plastigage to crankpin width. Place a strip on the crankpin parallel to the crankshaft installed in the correct position. Tighten the connecting rod big end nuts to the specified torque (see Connecting Rod I ...