Kawasaki Ninja Service Manual: Intake Air Pressure Sensor #1 (Service Code 12)

Kawasaki Ninja Service Manual / Self-Diagnosis System / Intake Air Pressure Sensor #1 (Service Code 12)

Main Throttle Sensor Output Voltage Inspection
Measure the output voltage at the main throttle sensor in the same way as input voltage inspection, note the following. Disconnect the main throttle sensor connector and connect the setting a ...

Intake Air Pressure Sensor #1 Removal
NOTICE Never drop the intake air pressure sensor #1 especially on a hard surface. Such a shock to the sensor can damage it. Remove: Air Cleaner Housing (see Air Cleaner Housing Removal in t ...

Other materials:

Engine Oil Flow Chart
1. Oil Screen 2. Oil Pump 3. Oil Pressure Relief Valve 4. Oil Filter 5. Oil Pipe 6. Oil Cooler 7. Balancer Oil Passage 8. Main Oil Passage 9. Crankshaft Oil Passage 10. Oil Pressure Switch 11. Camshaft Oil Passages 12. Drive Shaft Oil Passage 13. Output Shaft Oil Passage 14. Starter ...

Drive Chain Lubrication Condition Inspection
If a special lubricant is not available, a heavy oil such as SAE 90 is preferred to a lighter oil because it will stay on the chain longer and provide better lubrication. If the chain appears especially dirty, clean it before lubrication. NOTICE The O-rings between the side plates seal ...

Stator Coil Installation
Apply a non-permanent locking agent to the threads of the stator coil bolts and tighten them. Torque - Stator Coil Bolts: 12 N·m (1.2 kgf·m, 106 in·lb) Using a high flash-point solvent, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clea ...