Kawasaki Ninja Service Manual: Seat Covers

Kawasaki Ninja Service Manual / Frame / Seat Covers

Center Inner Fairing Installation
Installation is the reverse of removal. Note the following. Insert the hook portion [A] of the center inner fairing into the slot [B]. ...

Seat Cover Removal
Remove: Rear Seat (see Rear Seat Removal) Remove the bolts [A]. Remove the upper seat cover backward [B] to clear the hook portions. Remove: Front Seat (see Front Seat Removal) ...

Other materials:

Radiator Fan Relay Inspection
Refer to the Relay Circuit Inspection in the Electrical System chapter If the radiator fan relay is normal, check the wiring for continuity, using the wiring diagram in this section. Special Tool - Hand Tester: 57001-1394 If the wiring is good, check the ECU for its ground and power supp ...

Flap and Rear Fender Rear Installation
Installation is the reverse of removal. Note the following. Fit the tab [A] to the slot [B]. Run the seat lock cable [C] between the tool kit case and the turn signal light as shown in the figure. When installing the dampers [A] on the lower pipe [B], install it as shown in the figure. ...

Shift Fork Guide Pin/Drum Groove Wear Inspection
Measure the diameter of each shift fork guide pin [A], and measure the width [B] of each shift drum groove. If the guide pin on any shift fork is less than the service limit, the fork must be replaced. Shift Fork Guide Pin Diameter Standard: 6.9 7.0 mm (0.272 0.276 in.) Service Limit: ...