Kawasaki Ninja Service Manual: Nozzle Assy Removal

Kawasaki Ninja Service Manual / Fuel System (DFI) / Nozzle Assy / Nozzle Assy Removal

Nozzle Assy Removal


Nozzle Assy
...

Nozzle Assy Installation
Replace the dust seals [A] with new ones. Apply engine oil to the new dust seals, and install them. Install the nozzle assy securely. Push the four mounting positions of the injectors. Set ...

Other materials:

Rear Sprocket Warp Inspection
Raise the rear wheel off the ground with the stand so that it will turn freely. Set a dial gauge [A] against the rear sprocket [B] near the teeth as shown in the figure, and rotate [C] the rear wheel to measure the sprocket runout (warp). The difference between the highest and lowest di ...

Shift Pedal Removal
Remove: Shift Lever Bolt [A] Front Footpeg Bracket Bolts [B] If the tie-rod [C] is to be removed from the shift pedal and the shift lever, loosen the tie-rod locknuts [D]. The front tie-rod locknut is left-hand thread. Remove: Shift Pedal Mounting Bolt [A] ...

Lights and Switches Operation Inspection
First Step Set the gear position in the neutral position. Turn the ignition switch to ON. The following lights should go on according to below table. If the following light does not go on, inspect the meter unit (see Meter Unit Inspection in the Electrical System chapter). ...