Kawasaki Ninja Service Manual: Check 2-1: Speedometer Inspection

Kawasaki Ninja Service Manual / Electrical System / Meter, Gauge, Indicator Unit / Meter System Inspection / Check 2-1: Speedometer Inspection

If the display function does not work, check the following parts.

Rear Wheel Rotation Sensor (see Wheel Rotation Sensor Inspection in the Brakes chapter) ECU (ECU Power Supply Inspection in the Fuel System (DFI) chapter) Wiring (see Meter Unit Circuit)

If the above parts are good, replace the meter unit.

Meter System Inspection
...

Check 2-2: Fuel Level Warning Inspection
Remove: Fuel Tank (see Fuel Tank Removal in the Fuel System (DFI) chapter) Connect the resistor(s) [A] (about 50 to 100 Ω) between the fuel pump connector terminal [B] of the main harn ...

Other materials:

Brake Disc Installation
Install the brake disc on the wheel so that the marked side [A] faces out. Front Brake Discs [B] Rear Brake Disc [C] Apply a non-permanent locking agent to the threads of the brake disc mounting bolts. Tighten: Torque - Brake Disc Mounting Bolts: 27 N·m (2.8 kgf·m, 20 ...

Engine Oil Flow Chart
1. Oil Screen 2. Oil Pump 3. Oil Pressure Relief Valve 4. Oil Filter 5. Oil Pipe 6. Oil Cooler 7. Balancer Oil Passage 8. Main Oil Passage 9. Crankshaft Oil Passage 10. Oil Pressure Switch 11. Camshaft Oil Passages 12. Drive Shaft Oil Passage 13. Output Shaft Oil Passage 14. Starter ...

Electrical Wiring
Wiring Inspection Visually inspect the wiring for signs of burning, fraying, etc. If any wiring is poor, replace the damaged wiring. Pull each connector [A] apart and inspect it for corrosion, dirt, and damage. If the connector is corroded or dirty, clean it carefully. If it is da ...